NEW Gas Detection Modules Total 9 Piece Set MQ2 to MQ135

Description

DETECTION SMOKE SENSOR MODULE METHANE LIQUEFIED GAS STARTER DIY KIT MQ2 TO MQ135
Using high-quality dual-panel design, with power indicator and TTL signal output instructions.
The switching signal having a DO (TTL) output and analog output AO.
TTL output valid signal is low. ( Low-level signal when the output light can be directly connected to the microcontroller or relay module )
Analog output voltage with the higher concentration of higher voltage
There are four screw holes for easy positioning.
Has a long life and reliable stability
Rapid response and recovery characteristic
Input voltage : DC5V Power consumption ( current ): 150mA
DO output : TTL digital 0 and 1 ( 0.1 and 5V)
AO output :0.1-0 .3 V ( relative to pollution ) , the maximum concentration of a voltage of about 4V
Special note: After the sensor is powered, needs to warm up around 20S,measured data was stable, heat sensor is a normal phenomenon, because the internal heating wire, if hot is not normal .
Wiring:
VCC: positive power supply (5V)
GND: power supply is negative
DO: TTL switching signal output
AO: analog signal output
NOTE:
After the sensor is powered, need to warm about 20S, measured data becomes stable, heat sensor is normal
BUY FROM ME AND YOU WONT WAIT OVER A MONTH HAVING IT SHIP FROM CHINA AS I AM IN USA!